Add Button - Devolo WiFi 6Repeater 3000 Manual

15 Introduction
Fig. 3: Ethernet port

2.2.1Add button

This button controls the following functions:
Connecting the WiFi 6 Repeater 3000 to the
router via WPS
1
If the device is still set to factory defaults,
press the Add button for approximately 3 to 9
seconds to activate WPS.
2
Then press the WPS button on your router
within 2 minutes.
For information about the WPS function/ac-
tivation of your WiFi router, refer to the cor-
responding product documentation.
devolo WiFi 6 Repeater 3000
Now the WiFi 6 Repeater 3000 is connect-
ed to the router.
Connecting Wi-Fi clients to the
WiFi 6 Repeater 3000 via WPS
1
Press the Add button for approximately 1 to 3
seconds to activate WPS.
2
Then either press the WPS button of the Wi-Fi
device you are adding or enable the WPS
mechanism in the Wi-Fi settings of the Wi-Fi
device. Now the devices exchange their secu-
rity IDs and establish a secure Wi-Fi connection.
Now the desired Wi-Fi clients are connect-
ed to the WiFi 6 Repeater 3000.
3
If the Wi-Fi connection is switched on and you
want to copy these settings to a devolo Magic
or Wi-Fi adapter, continue reading Chapter
4.7.5 Config Sync.
WPS is one of the encryption standards de-
veloped by the WiFi Alliance. The objective
of WPS is to make it easier to add devices to
an existing network. For more detailed in-
formation, refer to Chapter 4.5.8 Wi-Fi Pro-
tected Setup (WPS).