Installation Via App - Devolo WiFi 6Repeater 3000 Manual

23 Initial use
1
Plug the WiFi 6 Repeater 3000 into a power
socket near your router for the initial set-up.
2
As soon as the dot of the Wi-Fi LED is lit green,
the device is ready to operate. It takes up to
2 minutes from the time the device is plugged
in until this status is reached.
The WiFi 6 Repeater 3000 has two different oper-
ating modes. It can be operated as a WiFi repeater
or an access point. Observe the specific procedures
based on the desired device mode.
devolo Home Network App
The devolo Home Network App automatically de-
tects the
Repeater 3000. A wizard guides you quickly and
easily through the process for setting up the device
as a WiFi repeater or access point (see 3.3.1 Instal-
lation via app).
Web interface of the device
Set up the device as a WiFi repeater or access point
manually by using the web interface of the WiFi 6
Repeater 3000 (see 3.3.2 Installation via web in-
terface).
devolo WiFi 6 Repeater 3000
new or unconfigured
WPS activation by means of Add button
You can automatically set up the device as a Wi-Fi
repeater by pressing the Add button (WPS activa-
tion) (see 3.3.5 Configuration as a repeater using
the Add button (WPS)).

3.3.1 Installation via app

1
Download the devolo Home Network App to
your smartphone or tablet computer from the
corresponding store.
WiFi 6
Fig. 4: QR code
2
The devolo Home Network App is put on the
app list of your smartphone or tablet as usual.
Tapping on the devolo Home Network App
icon brings you to the start menu.
3
Then follow the prompts of the wizard.
Once the status bar is complete and both
LEDs on the device are lit green, the WiFi 6
Repeater 3000 has been successfully con-
figured as a repeater.