Soc), State Of Charge Of The Battery; Current Assist Level; Set The Intensity Of The Leds; Other Information Displayed By The Hmi - MAHLE X20 System Guia Del Usuario

MAHLE X20 System · Operation and Use
014
V.1.0.1 - 04/2022

3.6.1. (SOC), State of Charge of the battery

The Head Unit will display the current battery status
(SOC) through the visible length of the LED bar. 100%
capacity, are represented through the full length of the
line. As the battery is slowly draining, the illuminated
length of the LED bar will decrease representing the
decrease in capacity. The LED bar will always keep a
minimum of one LED illuminated to be able to display the
assist level used.
The LED line is generated by 7 LEDs that can create
visual effects and animations. For the charging status and
the length of the illuminated LED bar the relation is the
following:
100% 90% 80% 65% 50% 35% 15% 10%
Iluminated LEDs
#7
#6
#5
#4
#3
#2
#1
#1 (Blink slow)
#1 (Blink fast)
5-10% SOC - The system is limited to a maximum of 70%
of its maximum nominal power output.
0-5% SOC - The system is limited to a maximum of 40%
of its maximum nominal power output.

3.6.2. Current Assist Level

The system includes three different assist levels, which
can be customize by the user, using the MAHLE APP My
SmartBike. Each Assist level is represented by a different
color as seen in the following table:
Level Color
0 - No assist White
1 - Minimum Green
2 - Medium Clear Brown
3 - Max Purple
Blink
Slow Blink
Fast
5%
SOC
94 - 100%
82 - 93%
70 - 81%
56 - 69 %
36 - 55%
16 - 35%
0 - 15%
0 - 10 %
0 - 5 %
RGB
#585858
#00710F
#EE420F
#9416FF

3.6.3. Set the intensity of the LEDs

The main HMI button has a light sensor integrated. Using
this sensor, the HMI automatically will increase or
decrease the intensity of the LED line, to improve the
visibility of the information.
3.6.4. Other Information displayed by the
HMI
The battery status and the assist level are displayed
through the color and the length of the LED bar.
Depending on the status of the eBike system, additional
information can be communicated
Switching the bike OFF
A white color appears after briefly pressing the button
down.
Switching the bike ON
A white color appears after briefly pressing the button
down.
Charging Status while charge
Cyan color appears with a pulsating effect.
Battery Charged
Permanent green LED bar.
BLE connected or disconnected
Blue color appears.
Lights switched ON or OFF
Yellow outer color appears when lights are switched ON
Lights ON
Yellow inner color appears when lights are switched OFF
Lights OFF
Error
Flashing red light when the system is having an active
error. Please switch off the system and ensure the error is
solved.
Error
WARNING
Flashing orange light when the system is having an active
warning alert. The use of the system is not restricted but
attention should be paid to the warning.
Updating in progress
Flashing pink light when software update is performed on
the system.
Walk assist mode activated
The color of the current assist level will be displayed at
50% of the LED bar, when the walk mode is active. This
will be visible while the mode is active.
Warning