Operation With The Charger; X20 Smartbike Active Charger; Charging Process; Error While Charging Process - MAHLE X20 System Guia Del Usuario

3.7. Operation with the Charger

3.7.1. X20 My SmartBike Active Charger
X20 My SmartBike Active Charger includes CAN BUS
communication and a Micro-USB interface to perform
updates on full eBike System. This charger is compatible
with all X20 MAHLE inner batteries and Range Extenders.
The Active Charger allows fast charging with up to 4A,
using the CAN Communication port to identify the battery
model and current charging status, supplying the
appropriated charging current depending on the current
SOC.
It does include 2 LED bars to inform about the charging
mode and status, projecting a retro-illumination against
any surface i.e., the wall or the floor.
As an optional component there is a wall mount available
to place the Active Charger on the wall, keeping the
wiring organized when not connected to the eBike or
while charging.

3.7.2. Charging Process

To ensure that it is being charged correctly, please follow
these instructions
1. Connect the charger to the power outlet.
LED of the charger will display a steady
WHITE light.
Make sure there is no cable connected
to the micro-USB port before charging.
2. Connect the charger to the charging port on the eBike
LED of the charger and the HMI of the
bike will turn CYAN.
Breathing effect: From high to low
frequency by increasing
charge.
3. Charge process finished
Once charging is completed, the LED
of the HMI will be a steady GREEN
light.
Disconnect the charger from the
power source before disconnecting
from the eBike.
Error during charging process
If a critical error occurs while charging,
the LED of the charger will flash in
RED.
level of

3.8. Updating Process

It is possible to update the system by using the
micro-USB port of the smart charger. To perform an
update, you need to connect the charger to your
computer and transfer the updating files to the charger.
Please follow this process:
3.8.1. Uploading files to the Active Charger
1. Disconnect the charger of the Power outlet
No LED will be operating.
2. Connect the charger to your computer using
micro-USB port
LED of the charger and the HMI will
turn to a PURE BLUE light.
Copy the unzipped update
(update_MUT.bin) to the new Drive Unit
(MAHLE_UTOOL) which will appear on
your computer and safety remove the
new drive on your computer.
100
%
Updating...
3. Disconnect the charger of your computer
No LED will be operating.
Error while uploading
If an error occurred during the
uploading process, the LED of the
charger will turn to a steady RED light
for 10 seconds. After that, the charger
goes back to normal operation.
015
files