Pulsar One Holders; E-Shifters; E-Shifters Installation - MAHLE X20 System Guia Del Usuario

4.1.1. Pulsar ONE holders

There are two different optional holders to place the
display in 4 different positions. It is also possible to use
other GARMIN compatible device holders. To ensure a
safe installation, please ensure you are using a
compatible holder with your Pulsar ONE display:
Pulsar ONE Sport holder
SKU: 330 100 000 01 000
Pulsar ONE Urban holder
SKU: 330 100 000 02 000

4.2. e-Shifters

e-Shifters is a set of 2 small optional buttons connected
to the Head Unit which allow to control the functions of
the MAHLE SmartBike System directly form the
handlebar (assist level, lights, etc.). The minimalist design
allows them to be installed independently from the
handlebar used (drop- or flat bar).
By pressing the e-Shifters, whether briefly or for longer,
different commands are sent to the system. A maximum
of 2 e-Shifters per eBike can be installed (left and right).
The e-Shifters give haptic feedback to the rider by
vibrating (under patent) whenever the status of the
system is changed to not draw the attention away from
riding.
Using the e-Shifters can help to increase the safety while
riding by avoiding removing the hand from the handlebar.
Additionally, the vibration of e-Shifter buttons deliver
additional information to the rider when the APP or the
eBike system changes the status or reports an alert.
To upgrade e-Shifters to your X20 equipped bike, please
get in touch with your local dealer to ensure a correct
installation and connection to the X20 System. The
following configurations are available:
e-Shifter 720
SKU: 350 100 000 00 200
Giftbox + Y-Joint + 2 e-Shifters with 720mm length wire +
2 Silicon Bands + Manual
e-Shifter 970
SKU: 350 100 000 00 300
Giftbox + Y-Joint + 2 e-Shifter with 970mm length wire +
2 Silicon Bands + Manual

4.2.1. e-Shifters Installation

The e-Shifters allow to be installed in various ways and
areas of the handlebars. The included e-Shifter rubber
hoods can be used to install the e-Shifters in every
possible area of the handlebar. Without the rubber hoods,
the e-Shifters can be installed under the bar tape on drop
bars.
Curved - Road and Gravel
The ergonomic design of e-Shifters and rubber hoods
allows the installation in various areas of the handlebar.
017