Heating Water - Beem BASIC SELECTION Manual De Instrucciones

Ocultar thumbs Ver también para BASIC SELECTION:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

EN

Heating Water

In brewing mode the device can emit hot water, e.g. for tea, through the steam nozzle (6).
1. Fill the water tank (h) (see the "Handling and Operation" chapter – "Filling the Water Tank").
2. Switch on the device by pressing the
up and the control lamp
control lamp
3. Immerse the steam nozzle (6) fully in a suitable vessel.
Please Note! The device must remain in brewing mode for this function. Do NOT activate
steam mode!
4. Turn the steam power control (3) to the
5. Press the button
6. Once the required amount of hot water has run into the vessel, press the button
to stop water from being emitted.
7. If you no longer wish to use the device, press the
The device switches off and the operating lamp goes out.
If the device is not switched off manually, it automatically switches off after 25 minutes in
stand-by mode.
Recipes for Speciality Coffees
Cappuccino
Cappuccino is normally made from one third espresso, one third hot milk and one third milk froth.
The cup should be thoroughly preheated as the drink is prepared in several steps.
1. First prepare the espresso (see the "Preparation" chapter – "Preparing Espresso or Coffee").
2. Then place the cup down on the hotplate (1) so that the espresso remains as hot as possible.
3. In comparison to the espresso, pour twice the amount of milk into the frothing container
and froth up half of the milk (see the "Preparation" chapter – "Preparing Milk Froth").
The other half of the milk remains liquid.
4. Hold back the milk froth with a spoon or plastic spatula and pour the hot milk over the
espresso.
5. Scoop the milk froth out of the frothing container with a spoon and spread it as a crest on
the cappuccino.
6. Sprinkle a little cocoa powder or cinnamon over the milk froth as you wish.
fl ashes. The device starts the heating process. As soon as the
is constantly lit, the device is preheated
(2). Hot water comes out of the steam nozzle.
button (11). The operating lamp 
position.
button for approx. 3 seconds.
34
(10) lights
again

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Espresso-select05025

Tabla de contenido