Before Use; Fit Welding Mask; Using The Device - Parkside PISG 120 A2 Instrucciones De Funcionamiento Y De Seguridad

Safety instructions / Before use / Fit welding mask / Using the device
of the standard, arc welding
devices can still result in electro-
magnetic interferences in sensitive
systems and devices. The operator
is responsible for malfunctions
that occur through the arc while
welding and must take suitable
protective measures. In doing so,
the operator must consider the
following:
– network, control, signal and
telecommunication lines
– computers and other micro-
processor-controlled devices
– TVs, radios and other playback
devices
– electronic and electrical safety
equipment
– people with cardiac pace-
makers or hearing aids
– measurement and calibration
devices
– interference immunity of other
equipment nearby
– the time at which the welding
work is carried out.
The following is recommended
to reduce possible interference
radiation:
– equip the mains connection
with a mains filter
– the welding device must be
regularly maintained and kept
in a good condition
– welding cables should be
completely uncoiled and run as
close to parallel with the floor
as possible
– devices and systems that are
compromised by the inter-
ference radiation must be
removed from the welding area
or shielded.
z Before use
Take the device and accessories out
of the packaging and check them for
damage (e.g. transport damage).
Fix the carrying strap
„
device (see Fig. C1–C4).
Connect the electrode holder
„
the earth terminal
device.
Position an electrode in the clamps
„
of the electrode holder.
z Fit welding mask
Fit the handle
„
mask , as shown in Fig. A.
7
Fit the protective glass
„
welding mask
Fig. A.
The protective glass
„
pushed in from the top.
Note: If you are not able to push the
protective glass
10
on the outside of the protective glass
z Using the device
Note: The welding device is designed
for welding with electrodes.
Use the electrode holder clamps
„
without protruding bracket screws,
which meet the current safety
standards.
onto the
1
5
to the welding
4
onto the welding
8
on to the
11
, as shown in
7
must be
10
in fully, gently press
and
.
10