Megger AVOMETER 8 Mk7 Guia Del Usuario página 2

G
SAFETY WARNINGS
The circuit under test must be switched off and de-energised before test connections are
made for Resistance measurement.
To measure current, de-energise the circuit to be tested, connect the test leads and then re-
energise the circuit.
Selector switches must be set to the correct positions.
When taking voltage measurements, never switch to Current (mA or A) or resistance (Ω).
Do not use with current transformers.
Check that the Instrument protection fuse is intact before and after making any measurement.
Replacement fuses must be of the correct type and rating.
UK Safety Authorities recommend the use of fused test leads when measuring voltage on high
energy systems.
Test leads, prods and crocodile clips must be in good order; clean, and with no broken or
cracked insulation.
Use fully shrouded test leads and take extra care when taking measurements above 50 V a.c.
The instrument must not be used if any part of it is damaged.
Warnings and precautions must be read and understood before an instrument is used. They
must be observed during use.
NOTE
THE INSTRUMENT MUST ONLY BE USED BY SUITABLY TRAINED AND COMPETENT PERSONS.
2