Repair And Warranty - Megger AVOMETER 8 Mk7 Guia Del Usuario

REPAIR AND WARRANTY

The instrument circuit contains static sensitive devices,
and care must be taken in handling the printed circuit
board. If the protection of an instrument has been
impaired it should not be used, and be sent for repair by
suitably trained and qualified personnel. The protection
is likely to be impaired if, for example, the instrument
shows visible damage, fails to perform the intended
measurements, has been subjected to prolonged storage
under unfavourable conditions, or has been exposed to
severe transport stresses.
New Instruments are Guaranteed for 1 Year
from the Date of Purchase by the User.
Note: Any unauthorized prior repair or adjustment will
automatically invalidate the Warranty.
Instrument Repair and Spare Parts
For service requirements for Megger Instruments contact:
Megger Limited or Megger
Archcliffe Road Valley Forge Corporate Center
Dover 2621 Van Buren Avenue
Kent, CT17 9EN. Norristown, PA 19484-9007
England. U.S.A.
Tel:+44 (0) 1304 502243 Tel: +1 (610) 676-8500
Fax:+44 (0) 1304 207342 Fax: +1 (610) 676-8610
42
Approved Repair Companies
A number of independent instrument repair companies
have been approved for repair work on most Megger
instruments, using genuine Megger spare parts. Consult
the Appointed Distributor / Agent regarding spare parts,
repair facilities and advice on the best course of action to
take.
Returning an Instrument for Repair
If returning an instrument to the manufacturer for repair,
it should be sent freight pre-paid to the appropriate
address. A copy of the Invoice and of the packing note
should be sent simultaneously by airmail to expedite
clearance through Customs. A repair estimate showing
freight return and other charges will be submitted to the
sender, if required, before work on the instrument
.
commences