Chip Extraction; Saw Blade Selection - Mafell K85Ec Instrucciones De Funcionamiento Y Seguridad

Use the following procedure to route the
connecting cable:
1. Route the connecting cable in the direction of
the cable grommet, away from the machine.
➢ For support, use the Velcro fastener on
the hose connector.
2. Always keep the connecting cable as far away
as possible from the tool.
✓ Connecting cable routed.

4.3 Chip extraction

For all work that produces a significant amount of dust, connect the machine to a suitable external extraction
device. The air velocity must be at least 20 m/s [65 ft/sec].
The inner diameter of the hose connector is 35 mm [1.4 in].

4.4 Saw blade selection

To achieve good cutting quality, use a sharp tool and select a tool from the following list that is appropriate for
material and application:
Cutting softwood and hardwood across and along the grain direction:
- Carbide circular saw blade Ø 237 x 2.5 x 30 mm, 24 teeth [Ø 9.3 x 0.1 x 1.2 in]
Cutting softwood and hardwood especially along the grain direction:
- Carbide circular saw blade Ø 237 x 2.5 x 30 mm, 12 teeth [Ø 9.3 x 0.1 x 1.2 in]
Cutting softwood and hardwood especially across the grain direction:
- Carbide circular saw blade Ø 237 x 2.5 x 30 mm, 56 teeth [Ø 9.3 x 0.1 x 1.2 in]
Cutting wood fiber insulation material:
- Carbide circular saw blade Ø 237 x 2.5 x 30 mm, 56 teeth [Ø 9.3 x 0.1 x 1.2 in]
Cutting plastic material (styrofoam):
- Carbide circular saw blade Ø 237 x 2.5 x 30 mm, 24 teeth [Ø 9.3 x 0.1 x 1.2 in]
14
Caution
Health hazards from wood dust
The dusts produced during work can be inhaled and can cause health damage.
Harmful dust must be extracted with a HEPA 13 dust extractor.
➢
Wear a dust mask during work.
➢
Fig. 6: Routing the connecting cable
K85Ec / KSS80Ec 370
01/2022