Setting For Bevel Cuts - Mafell K85Ec Instrucciones De Funcionamiento Y Seguridad

K85Ec / KSS80Ec 370

5.7 Setting for bevel cuts

For bevel cuts, the saw unit can be set to any angle from 0° to 60°.
Use the following procedure to set the saw unit
for bevel cuts:
1. For tilting, put down and support the machine
so that the saw unit can be tilted.
2. Loosen the wing screw (10).
3. Use the scale (9) on the tilting segment to set
the angle.
4. Tighten the wing screw (10).
✓ The saw unit is set to the desired angle
for the bevel cut.
01/2022
Fig. 17: Setting the saw unit for bevel cuts
21