Handling At Overload; Cutting Depth Setting - Mafell K85Ec Instrucciones De Funcionamiento Y Seguridad

As soon as the braking time exceeds 7 seconds, have the machine checked and a new
brake pad installed.

5.5 Handling at overload

Switch off the machine in the event of an overload. Switch the machine back on and continue sawing at a
reduced feed rate.

5.6 Cutting depth setting

The cutting depth can be set continuously in a range between 0 and 88 mm [0 to 3.5 in].
Use the following procedure to set the cutting
depth:
1. Press and hold the pushbutton (18).
The cutting depth is indicated on the
➢
scale (2) on the cover. The area with a
red background of the plunge lever (1)
serves as pointer.
2. Use the plunge lever (1) to set the cutting
depth.
3. Release the pushbutton (18).
✓ The cutting depth is set.
For separating cuts, always set the
cutting depth to approx. 2 ... 5 mm
[0.08 ... 0.2 in] more than the
material thickness you want to cut.
20
Fig. 16: Setting the cutting depth
K85Ec / KSS80Ec 370
01/2022