Sawing Along Markings - Mafell KSS300 Instrucciones De Funcionamiento Y Seguridad

Using the Flexi bar:
The Flexi bar allows straight and diagonal cuts up to 1.4 m (55.12 in) cutting length.
Use the following procedure to work with the
Flexi bar:
1. Put the Flexi bar on the workpiece.
2. Align the Flexi bar on the workpiece.
3. Fit the two clamping claws (19) on the Flexi bar.
4. Clamp the two screw clamps (20) to secure on
the two clamping claws (19) and the workpiece.
The Flexi bar is secured on the workpiece.
➢
5. Set the desired cutting depth and the inclination
angle on the machine.
6. Position the machine at the red handle of the
Flexi bar such that the guide elements (17) of
the bar engage in the groove of the base plate.
7. Switch on the machine.
8. Push the machine steadily forward in working
direction.
9. Switch off the machine after you have finished
machining the workpiece.
10. Remove the machine from the Flexi bar.
Machining with the Flexi bar completed.
✓

5.9 Sawing along markings

The base plate has a tracing edge (21), which can be
used for vertical cuts as well as for angular cuts. This
tracing edge (21) corresponds to the inside (side
facing the motor) of the saw blade.
For bevel cuts, the marking can be seen through the
opening on the inside of the upper guard (left in
cutting direction).
24
Fig. 18: Using the Flexi bar
Fig. 19: Tracing edge
KSS300
01/2022