Cleaning And Maintenance - Infiniton HBR-W350 Manual De Usuario

OPERATION OF YOUR HEATER
·Remove the heater from all packaging and place it in desired location.
·Ensure that there is a safe area between the heater and furniture,curtains,etc-50cm safe
area form top and sides and 120cm safe area in front.
·Unwind the Power Cord and plug it into the Power Outlet.
·To activate the heater ,turn the knob clock-wise to the 'FAN' position for cool air. Turn knob
to 'I' for low power, 'II' for maximum power.
AUTO SATETY SHUT OFF
The heater has a built-in safety device, which will switch the heater OFF in case of
accidental over heating. To reset the heater, follow the next steps:
·Turn the control setting to the 'O' position.
·Unplug the heater and wait 5-10minutes for the unit to cool down.
·After the unit has cooled, plug it in and operate normally.
·Turn selector switch into desired position(Fan, Low or High).
·Turn the thermostat switch to the desired temperature position.
·When you feel the room temperature comfortable, turn the thermostat switch
anti-clockwise slowly to the minimal direction until the appliance switches off.
·The thermostat switch will keep the room temperature at the desired temperature a
utomatically.
·You can also turn the thermostat switch anti-clockwise to the minimum position or turn the
thermostat switch clockwise to the maximum position to make the temperature lower or
higher.

CLEANING AND MAINTENANCE

·Be sure to switch off power supply and pull out the plug before cleaning.
·Wait for the heater to cool down sufficiently.
·Clean the body of the heater with a damp cloth. DO NOT ALLOW water into the appliance.
·DO NOT use soap or chemicals which may damage the housing of the heater.
·Allow sufficient drying time before operating again.
·Clean the air inlets and outlets regularly with a vacuum cleaner(with a regular use, at least
twice a year).
·When the unit is not in use. we recommend that the heater is re-packed in its original
packaging and stored in a cool ,dry place.