Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
The appliance requires no installation, it should be used solely as a portable appliance.
Portable appliances are not suitable for use in a bathroom.
OPERATION
Turn the thermostat knob (right) in a clockwise direction until it reaches the maximum
-
setting.
Summer service (ventilation only): turn the knob to setting
-
Heating at reduced power: turn the knob (right) to setting Ⅰ(1000W).
-
Heating at full power: turn the (right) to setting Ⅱ(2000W).
-
Switching off: turn the knob (left) to setting ○.
-
REGULATING THE THERMOSTAT
When the room has reached the required temperature turn the right thermostat knob (where
included) in an anti-clockwise direction up to the point where the appliance switches off and
not beyond. The temperature fixed in this way will be automatically regulated and kept at a
constant level by the thermostat.
CLEANING AND MAINTENANCE
Before cleaning always remove the plug from the electrical socket.
Clean the air inlet / outlet grilles frequently.
Never use abrasive powders or solvents.
WARNINGS
Do not use the appliance in the vicinity of showers, bath tubs, wash basins, swimming
-
pools, etc.
Always use the heater in an upright position.
-
Do not use the heater to dry your laundry. Never obstruct the intake and outlet grilles
-
(danger of overheating).
The heater must be positioned at least 50 cm from furniture or other objects.
-
Do not place it up against walls, furniture, furniture, curtains, etc.
-
This appliance comes with a Y-type connection. Replacement of the cable must be
-
entrusted only a technician authorized by the manufacturer, because such work requires
special tools.
The appliance must not be positioned directly underneath socket.
-
Do not use the appliance while it is functioning in order to avoid overheating with the
-
attendant risk of fire.
Do not use the appliance in rooms less than 4m
-
The heater is fitted with a safety device which will switch off the heater in case of accidental
overheating (eg. obstruction of air intake and outlet grilles, motor turning slowly or not at all).
To reset, disconnect the plug from the power for a few minutes, remove the cause
of overheating then plug the appliance in again.
2
area.
.
Publicidad
Tabla de contenido
