Wireless Remote Control - Champion Global Power Equipment CPG4000DHY-EU Manual Del Operador

CPG4000DHY-EU - 3500W WIRELESS REMOTE START OPEN FRAME INVERTER

Wireless Remote Control

This generator is equipped with a RED wireless remote control
system for starting and stopping. The system consists of (4) main
components:
1. Receiver Control Module (RCM)
2. Remote Control
3. Start/Stop button
4. Auto-Choke
The Remote Control functions are enabled when:
1. The START/STOP button is in "STANDBY" mode and flashes
green once per second.
The Remote Control functions are disabled when the above
condition is not met.
To start the generator wirelessly, press the "START" a button on
on the Remote Control one time to enter standby mode, indicated
by the START/STOP button on control panel flashing green once
per second. Press the "START" button on the Remote Control
again to start the engine. The engine will attempt to start (6)
times. The RCM controls the Auto-Choke during each attempt
to start. If the generator does not start, call Champion Customer
Care team for assistance at +44(0)1942-715-407.
To stop the generator wirelessly, press the "STOP" $ button on
the Remote Control one time.
Remote Control Power Consumption
While the START/STOP button is in "STANDBY" mode and flashing
green once per second, the RCM is active and waiting for a remote
signal. This standby function requires a small amount of electrical
current from the battery and will shut off automatically after 12
hours.
Pushing and holding the "STOP" $ button on the remote control
for 5 seconds or pushing and holding the START/STOP button
on the control panel for 5 seconds disables the standby function
manually and the RCM will no longer consume any battery power
or wait for remote signal. This is indicated by the START/STOP
button no longer flashing.
RED Statement for Remote Control Device
1. This device complies with RED Rules. Operation is subject to
the following two conditions:
1a. This device may not cause harmful interference.
1b. This device must accept any interference received,
including interference that may cause undesired
operation.
2. Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
This equipment has been tested and found to comply with
latest EU 'RED' directive. These limits are designed to provide
protection against harmful interference in a residential or
commercial installation/areas. This equipment generates, uses
and can radiate radio frequency energy and if not installed and
used correctly in accordance with the instructions, may cause
some harmful interference to radio communications. If this
equipment does cause harmful interference to radio equipment
reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and
receiver.
– Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Call technical help on +44(0)1942-715-407 for assitance.
13
CONTROLS AND FEATURES
NOTICE

EN