Champion Global Power Equipment CPG4000DHY-EU Manual Del Operador página 16

CPG4000DHY-EU - 3500W WIRELESS REMOTE START OPEN FRAME INVERTER
No oil in engine, recommended 10w30 Non
synthetic engine oil needs to be added.

DO NOT attempt to crank or start the engine before it has
been properly filled with the recommended type 10w30 Non
synthetic and amount of oil. Damage to the generator as
a result of failing to follow these instructions will void your
warranty.

The generator rotor has a sealed, pre-lubricated ball bearing
that requires no additional lubrication for the life of the bearing.

The recommended oil type for typical use is 10W-30 oil.
However, using the listed conventional oils shown in the
"Recommended Engine Oil Type" chart may be used for typical
use including the first 5 hours of the break-in run time period
of the engine.
If running generator in extreme temperatures, refer to the
"Recommended Engine Oil Type" chart.
Recommended Engine Oil Type
5W-30
5W-30 Full Synthetic
°F -20 0 20
°C -28.9 -17.8 -6.7
Ambient temperature
CAUTION
NOTICE
NOTICE
10W-30
10W-40
40 60 80 100
4.4 15.6 26.7 37.8 48.9
1. Place the generator on a flat, level surface.
2. Remove oil fill cap/dipstick to add oil.
3. Using a funnel, add up to 20.3 fl. oz. / 0.6 qt. (0.6 L) of oil (not
included) and replace oil fill cap/dipstick. DO NOT OVERFILL.
4. Check engine oil level at every use and add as needed.
MAX
Check oil level often during the break-in period. Refer to the
Maintenance section for recommended service intervals.
This engine is equipped with a low oil shut-off and will stop
when the oil level in the crankcase falls below the threshold
level.
As a good general rule of thumb the bottom 2 threads on the
oil port is full, Always make sure the generator is level and
never tip the generator to check oil levels.
The first 5 hours of run time are the break-in period for the
unit. During the break in period stay at or below 50% of the
running watt rating and vary the load occasionally to allow
stator windings to heat and cool. Adjusting the load will also
cause engine speed to vary slightly and help seat piston rings.
120
After the 5 hour break-in period, change the oil.
16
ASSEMBLY
OIL DIP STICK
NOTICE

CAUTION

CAUTION

NOTICE
