Dip Switch Settings Overview; Function Setting - Airwell AW-WHPMA04-H91 Manual De Instalación

Temperature curves for cooling mode
T4 - 10≤ T4＜15 15≤ T4＜22
1- T1S 16
2- T1S 17
3- T1S 18
4- T1S 19
5- T1S 20
6- T1S 21
7- T1S 22
8- T1S 23
T4 - 10≤ T4＜15 15≤ T4＜22
1- T1S 20
2- T1S 21
3- T1S 22
4- T1S 23
5- T1S 24
6- T1S 24
7- T1S 25
8- T1S 25
The automatic setting curve is the ninth curve,the ninth curve can be set as following:
T1S (T1S2)
T1SETC1
T1SETC2
T4C1
State:In the setting the wired controller, if T4C2<T4C1,then exchange their value; if T1SETC1<T1SETC2, then
exchange their value.

10.2 DIP switch settings overview

10.2.1 Function setting

DIP switch S1,S2 and S4 are located on the main control hydraulic module board (see "9.3.1 main control board of hydraulic
module").
Switch off the power supply before making any changes to the DIP switch settings.
22≤ T4＜30 30≤ T4
11 8 5
12 9 6
13 10 7
14 11 8
15 12 9
16 13 10
17 14 11
18 15 12
22≤ T4＜30 30≤ T4
18 17 16
19 18 17
20 19 17
21 19 18
21 20 18
22 20 19
22 21 19
23 21 20
T4
T4C2
WARNING
1 2 3 4 1
S1
2 3 4 1 2
S2 S4
50
3 4