Kingfisher CLBH60ASBL Manual De Instrucciones página 73

• The Light will be white or red.
• The display will show the motor speed from off as "A.O" up to boost as "A.P".
USING MANUAL MODE AND AUTOMATIC MODE
Automatic Mode
After calibration is completed, the hood will be configured in Automatic Mode and when the hood is turned
on, the sensor will take an initial reading of the air quality in your kitchen.
This will take around thirty seconds and the Air Sense Control will flash white. Once completed the Air
Sense control will change colour according to the air quality and set the fan speed automatically based upon
the table above.
NOTE:
1. If the display shows "A.O", the Air Sense icon is green, and the air quality does not alter, the hood will
automatically turn off after ten minutes.
2. If the display shows "A.1", the Air Sense icon is green, and the air quality does not alter, the hood will
automatically drop to "A.O" after five minutes.
Manual Mode
If you wish to control the hood manually you can switch to manual control by pressing the Fan Speed Up
control .The display will change from the current automatic speed and increase the fan speed by one, for
example from "A.1" to "S.2".
The display will also flash indicating that this is a temporary override and this will continue for five minutes
before returning to the previous automatic level setting.
Once in Manual Mode, you can control the fan speed by using the Fan Speed Down control
Speed Up control and by pressing the Air Sense Status control
speed and the display will stop flashing.
Alternatively, press the Air Sense Status control
Troubleshooting
Problem
Excessive vibration.
The light is on, but the
fan does not work.
Both the light and
motor do not work.
5059340445953_MNL_IN_V04.indb 72 5059340445953_MNL_IN_V04.indb 72
Possible cause
The appliance is not installed properly
on the brackets.
The fan blade is damaged.
The fan motor is not fixed tightly.
The fan blade is jammed.
The motor is damaged.
Light bulb blown.
Power connection loose.
once, this will confirm the new manual
again to return to Automatic Mode straight away.
Solution
Take down the appliance and check it
is properly fixed.
Switch off the appliance. Repair to
be carried out by qualified service
personnel only.
Ring the customer helpline at the end
of the Care & maintenance section to
arrange an engineer visit.
Check power supply.
72
and Fan
09-06-2022 14:31:37 09-06-2022 14:31:37