Parts And Components; Before Use; Installation - cecotec bolero SQUAD V 3000 Manual De Instrucciones

1. PARTS AND COMPONENTS

Fig. 1
1. Cooking area 1 (max. 1200 W)
2. Cooking area 2 (max. 1800 W)
3. Cooking area 3 (1050 / 1950 / 2700 W)
4. Glass plate
5. On/off button
6. Control panel
Control panel
Fig. 2
1. On/off button
2. Power buttons
3. Lock button
4. Timer button
5. Triple area button
The graphics in this manual are schematic representations and may not exactly match the
product.

2. BEFORE USE

- This product includes a package designed to protect it during transport. Unpack the
appliance and keep the original packaging and materials in a safe place. It will help prevent
any damage if the product needs to be transported in the future. In case the original
packaging is disposed of, make sure all packaging materials are recycled accordingly.
- Make sure all parts and components are included and in good conditions. If there is any
piece missing or not in good condition, immediately contact the Technical Support Service
of Cecotec.

3. INSTALLATION

Selection of the installation tools
Cut out the worktop where the hob is to be fitted according to the dimensions given in the
-
table below and figure 3.
For its installation and use, you must keep a space of at least 5 cm around the gap.
-
Make sure the worktop thickness is at least 30 mm. Select a worktop with a heat-resistant
-
and insulated material (wood or other similar fibrous or hygroscopic materials should not
ENGLISH
BOLERO SQUAD V 3000
51