Troubleshooting - cecotec bolero SQUAD V 3000 Manual De Instrucciones

Dirt on the touch
buttons

6. TROUBLESHOOTING

Problem Possible causes
The hob does There is no power
not turn on. supply
Touch buttons The buttons are
do not work. locked.
It is difficult to There may be a slight
use the touch film of water on
buttons. the buttons or you
may be using your
fingertip to press the
buttons.
The glass is Cookware with
damaged. rough edges. Use of
inappropriate and
abrasive scouring
pads or cleaning
products.
Unplug the cooking hob
1
from the mains.
Absorb the spill.
2
Clean the touch control
3
area with a clean, damp
sponge or cloth.
Dry the area completely
4
with a paper towel.
Reconnect the hob to
5
the mains if you wish to
continue using it.
The hob may beep and turn off, and
the touch buttons may not work
while liquid is on them.
Make sure you dry the touch control
area before switching the hob back
on.
Possible solutions
Make sure that the hob is connected to the mains
and that it is on.
Check if there has been a power failure. After
these inspections, if the problem persists,
contact the Technical Support Service.
Unlock the buttons. Check the 'Buttons lock'
section for instructions.
Make sure the touch control area is dry and use
your finger base to press the buttons.
Use cookware with flat and smooth bases. Check
the 'Selection of the suitable cookware' section.
Read the 'Cleaning and maintenance' section.
ENGLISH
BOLERO SQUAD V 3000
61