Operation - cecotec bolero SQUAD V 3000 Manual De Instrucciones

ENGLISH
Do not bend or press the cable.
-
Check the cable for damage regularly.
-
Note:
The lower surface and the power supply cable of the hob shall not be accessible after
installation.

4. OPERATION

This hob directly uses resistance wire heating, and adjusts the power output by adjusting
-
the power with the touch buttons.
Touch buttons
The buttons react to touch, so there is no need to apply any pressure.
-
Use the base of your finger, not the tip. Fig. 10
-
You will hear a beep every time the hob detects a finger.
-
Make sure the buttons are always clean, dry and there are no objects (for example, a
-
utensil or a cloth) covering them. Even a thin film of water can make it difficult to operate
the buttons.
Selection of the suitable cookware
Do not use kitchen utensils with serrated edges or with a curved base. Fig. 11
-
Make sure the base of the cookware is smooth, flat against the glass and has the same size
-
than the cooking area. Always centre the cookware in the cooking area. Fig. 12
Always lift the cookware off the ceramic hob, do not slide it, as it could scratch the glass.
-
Fig. 13
Start cooking
After turning on the hob, it will beep, all the indicators will turn on for 1 second and then they
will turn off, indicating the ceramic hob is on standby mode.
Fig. 14
1. Press the On/off button and all the indicators will show -.
2. Place suitable cookware in the cooking area you wish to use. Make sure the bottom of the
cookware and the cooking area surface are clean and dry.
3. Select the power by pressing the + and/or - buttons. If you do not select the power in 1
minute, the hob will turn off automatically. You must turn it on again and return to step 1.
You can modify the power any time while cooking. If you hold down any of these buttons,
the value will be set up or down.
54