Publicidad
Idiomas disponibles
Idiomas disponibles
Drive Unit Attachment
Making sure the wristband is off, power on the drive unit by flipping the toggle switch to the on position prior to attachment. "On" is push-
ing the toggle away from the front of the drive unit (Fig. N). You will get a loud beep and the blue LEDs will illuminate as indication.
The two spring loaded end caps engage the quick-release axle tips of the folding frame wheelchair that protrude out of the axle
receiver plugs. These spring loaded end caps are compressible to allow for clearance and then released to be positioned over these axle
tips (Fig. O). The tension force of the springs constantly push out to prevent the adaptor bar from coming off the wheelchair until it
is desired, at which point the end caps are compressed and the adaptor bar/drive unit are removed.
If buttons were purchased, refer to their separate instructions for
mounting directions. The buttons plug into to the drive unit using
the magnetic connector that snaps into the receptacle on the drive
unit housing (Fig. P).
Refer to the User's Manual for SmartDrive operation.
Fig. N
Fig. O
Fig. P
Publicidad
