Meter Operation; Manual Mode; Auto Batch Mode - Badger Meter LM OG-P2 Advanced Manual De Instalación Y Operación

Meter operation

6. Meter operation
NOTE: The keypad Auto button is used to toggle between Manual Mode and Auto Batch
Mode.
6.1

Manual mode

Manual mode
6.2

Auto batch mode

To enter the auto batch programming mode, press the
colon appear.
This screen appears.
Auto batch program mode
1. Press the
batch or manual mode.
2. When the desired batch number icon appears on screen, change the batch size by
pressing the
Auto batch program mode, option 1
In the manual mode the meter operates as a free flow-
dispensing handle.
1. Pull the trigger to begin the flow.
2. The display shows the amount dispensed.
3. When the desired amount has been dispensed,
release the trigger to stop the flow.
4. Press
to zero.
The meter is now ready to select the desired batch
number.
• The '0' is flashing in front of the colon. This is the batch
number icon.
• Batch '0' is for manual mode (see manual mode,
above).
• Batches '1', '2', '3', '4' and '5' are for auto batching
amounts up to 99 units.
• Different batch amounts can be stored in each option.
• Batch '6' is for batches between 1 and 999 units.
button to cycle through the batch number icons to select the desired
and buttons.
• Press the 10 button to increase a batch by 10 units.
• Press the 1 button to increase a batch by 1 unit.
• Press the 0.1 button to increase a batch by 0.1 of a
unit.
LM_OGP2Adv_BA_89_1008
button once to reset the counter display
button until a digit and
page 28/92