Change Factory Settings; Programming; Change Unit For Measure - Badger Meter LM OG-P2 Advanced Manual De Instalación Y Operación

Change factory settings

9. Change factory settings
Each meter is calibrated at the factory for use with motor oil (see "Change scale factor" under
point 9.3). The unit of measure is also selected prior to shipment.
Verify Firmware version
1. The firmware version and code checksum can be displayed by holding the
button at the same time.
2. The last two digits on the lower right are the firmware version.
3. Meters with version 17 or higher use the procedure outlined in this manual for changing
of unit of measure and scale factor.
9.1

Programming

To change the factory settings:
9.2

Change unit for measure

The meter comes with an option to choose 4 different units of measure.
Scale factor digits
Programming display
4. If L (liters) is selected, the decimal point begins to flash.
• You now have the option to change the decimal point to either a period or a comma.
• To do this, press the
1. Push and hold at the same time the
buttons.
2. PrG will appear on the display.
3. Release the
4. Then press and release in order the
5. The current unit of measure will now be flashing
indicating that you have entered the programming
mode.
1. The actual unit of measure is flashing when the
pogramming mode is entered.
2. Press the
options; PT, QT, GAL, L.
Unit of
measurement
3. When the desired unit of measure is displayed, press
the
flashing.
button.
LM_OGP2Adv_BA_89_1008
and
and the buttons.
button to toggle between the four
button. The unit of measure icon stops
page 33/92
and
buttons.
, ,
and
,