Emergency Override; History; Flow Rate - Badger Meter LM OG-P2 Advanced Manual De Instalación Y Operación

Operating mode functions
NOTE: The accumulated total cannot be reset unless the user changes from English
units to metric units or from metric to English units (see change factory settings, change
unit of measure under 9.2).
7.2

Emergency override

In case of an emergency or to interrupt a batch, the meter is equipped with an
emergency override.
1. Press the red
override closes the valve, immediately stopping fluid flow.
2. After an emergency override, batching can continue by pulling up on the trigger.
7.3

History

This option allows the user to review the previous five (5) batches dispensed with the
meter.
1. Press and hold the
History option
NOTE: The
or from metric to English units (see change factory settings under 9.1).
7.4

Flow rate

This option allows a user to see instantaneously the rate at which fluid is flowing
through the meter.
Press and hold the
meter. The flow rate appears in the bottom right hand corner of the display.
Flow rate option
NOTE: The flow rate can only be displayed if fluid is flowing through the meter.
button on the meter to activate the emergency override. The
/ HISTORY button to view the five (5) previous batches.
• The batches are displayed on screen, one at a time;
• The batches continue to cycle as long as the history
2. Two (2) seconds after releasing the history button
cannot be erased unless the user changes from English to metric
HISTORY
/ FLOW RATE button while fluid is flowing through the
• As long as the button is held down, the flow rate
• Releasing the button returns the display to the normal
LM_OGP2Adv_BA_89_1008
beginning with the most recent and cycling through
to the oldest.
button is held down.
the display automatically returns to the normal
operating screen.
remains on the display.
operating screen.
page 31/92