Connections And Rear Panel Overview - Teac T-H500 Manual Del Usuario

Connections and Rear Panel Overview

1LINE OUT jacks
Connect these jacks to the TUNER jacks on
the amplifier:
White pin-plug T White jack (left)
Red pin-plug T Red jack (right)
2REMOTE CONTROL jacks
These jacks are used for the connection of
the system for the purpose of operating the
system by means of the remote control
transmitter or system control signals.
Connect this jack A to jack A (or B) on
other unit either on or beneath this unit.
Note:
The remote control transmitter is not
provided with this unit.
Signal Input/Output cord
1
3
RESET Switch
OIn the following cases, function buttons
may not often work or may work
improperly.
1) When the system is damaged by some
electrical shock,
2) When the power is irregular or has
electrical noises.
In these cases, try as shown on the
right.
Press the RESET switch once or twice
with a pencil or a ball-point pen lightly.
* If you press this RESET switch, all the
memories will be erased. In this case, try
to preset stations again.
A-H500
Remote control cord
2 3
_ 4 _
T-H500