Troubleshooting - Teac T-H500 Manual Del Usuario

Troubleshooting

Before calling for service, check through the chart below for probable causes of the problems you experience while using this unit.
Problem
No sound.
Only noise is heard.
Broadcasting is received but with noise.
The preset call buttons on the remote
control do not work.
Probable cause(s)
INPUT SELECTOR of amplifier is not set to
"TUNER".
VOLUME of amplifier positioned in "MIN".
The terminal for system connection is
pulled out.
The antenna is pulled out.
The frequency is not detected exactly.
The position of antenna is not suitable.
The power of CD is turned on.
The remote control is set to a mode other
than tuner.
_ 11 _
Suggested remedy
Select "TUNER" in INPUT SELECTOR.
Adjust VOLUME accordingly.
Connect the terminal for system
connection correctly.
Connect the antenna on the rear panel.
Set the frequency correctly.
Install the antenna again after locating
the best reception position.
Turn off CD.
Select tuner on the remote control.