Descargar Imprimir esta página

BABYTREND muv PY74 Manual De Instrucciones página 8

Ocultar thumbs Ver también para muv PY74:

Publicidad

ASSEMBLY MONTAJE
FOLDING PLAYARD
CÓMO PLEGAR EL CORRALITO
7) • Release the hook and loop fastener holding
the Mattress from underneath the Playard
floor and set the mattress aside.
• Do not unlock top rails yet, center of floor
must be raised before top rails will unlock.
• Rotate the center handle counter-clockwise
90 degrees and raise the center as high as
the top rails (Fig. 7). Gather the Legs and
Wheels together towards the center as close
as possible so that they nearly touch.
• Suelte las correas de gancho y bucle cierre
que sostienen el colchón desde debajo del
piso del corralito de juegos y déjelas a un
lado.
• Todavía no destrabe las barandillas
superiores. El centro del piso debe estar
elevado antes de destrabar las barandillas
superiores.
• Gire el asa central 90 grados en sentido
antihorario y levante el centro a la altura
de las barandillas superiores (Fig. 7). Junte
las patas y las ruedas hacia el centro tan
cerca como sea posible, de manera que
prácticamente se toquen.
13
13
13
Copyright © 2022, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados.
Copyright © 2022, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados.
Copyright © 2022, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados.
Rotate before lifting
Girar antes de levantar
Fig. 7
8) • Locate the rail latch release in the center
and bottom side of each rail. Squeeze the
lever with two hands until the rail releases
the two tubes (Fig. 8a), then push down
(Fig. 8b).
NOTE: If the top rail(s) do not release
completely, DO NOT FORCE! Lift the
center of floor higher. Both tubes must be
released for the top rail to fold.
• Ubique el mecanismo de liberación del
sujetador de las barandillas en el centro
y la parte inferior de cada barandilla.
Presione la palanca con ambas manos
hasta que la barandilla suelte los dos tubos
(Fig. 8a), luego empuje hacia abajo (Fig.
8b).
NOTA: Si las barandillas superiores no se
sueltan completamente, ¡NO LAS FUERCE!
Levante el centro del piso más alto. Se
deben soltar ambos tubos para que la
barandilla superior se pliegue.
Copyright © 2022, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados.
Copyright © 2022, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados.
Copyright © 2022, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados.
Copyright © 2017, Baby Trend Inc., All Rights Reserved. Todos Los Derechos Reservados.
Copyright © 2017, Baby Trend Inc., All Rights Reserved. Todos Los Derechos Reservados.
Copyright © 2017, Baby Trend Inc., All Rights Reserved. Todos Los Derechos Reservados.
ASSEMBLY MONTAJE
Center latch
Tube
Tube
Sujetador central
Tubo
Tubo
Tube
Latch release
Mecanismo de liberación
TOP RAIL
BARANDILLA SUPERIOR
Push
Oprimir
2
Push
1
Oprimir
Fig. 8a
Fig. 8b
Tube
Tubo
14
14
14

Publicidad

loading