Emission Levels; Intended Use; Technical Data - Festool RG 130 ECI Manual De Instrucciones

English
2.4 Safety warnings for sanding tools
– Sanding tools are fragile, which is why you
must be extremely careful when handling
them. The use of damaged, incorrectly
clamped or inserted sanding tools is dan­
gerous and can cause serious injuries.
– Ensure that the sanding tools are not ex­
posed to any mechanical damage or harm­
ful environmental conditions during stor­
age.
– Handle and transport sanding tools with
care.
– Pay attention to the information on the la­
bel or the sanding tool itself, as well as us­
age restrictions, safety warnings or other
instructions. If any points are unclear when
choosing sanding tools, the user must con­
tact the manufacturer for information be­
fore using the tool.
– Sanding discs must be fitted in accordance
with section 6.4.
– Only experienced staff are permitted to fit
sanding tools.
2.5

Emission levels

The levels determined in accordance
with EN 62841 are typically:
Sound pressure level
Sound power level
Uncertainty
CAUTION
Noise generated when working
Risk of damage to hearing
► Use ear protection.
Vibration emission level a
three directions) and uncertainty K measured in
accordance with EN 62841:
The specified emission levels (vibration, noise)
– are used to compare machines.
– They are also used for making preliminary
estimates regarding vibration and noise
load during operation.
– They represent the primary applications of
the power tool.
20
L = 96 dB(A)
PA
L = 85 dB(A)
WA
K = 3.0 dB
(vector sum for
h
a = 4.0 m/s
h
K = 1.5 m/s
The emission values may deviate from the
specified values. This is dependent on how
the tool is used and the type of workpiece
being machined.
► The actual load during the entire operating
cycle must be evaluated.
► Depending on the actual load, suitable pro­
tective measures must be defined in order
to protect the operator.
► Grinding thin sheets of metal or other easi­
ly vibrating structures with a large surface
can result in a total noise emission much
higher than the declared noise emission
values. Such workpieces should as far as
possible be prevented from emitting sound
by suitable measures such as the applica­
tion of heavy flexible damping mats.
3

Intended use

The power tool is intended for surface sanding
on concrete surfaces, sanding off formwork
transitions and removing plaster, paint, adhe­
sive residue, coatings or rust and for cleaning
concrete and wooden surfaces.
The power tool is designed for use with special
sanding discs according to EN 13236 recom­
mended by the manufacturer (see section 6.4)
and must not be used with composite sanding
discs.
The power tool must only be used for dry sand­
ing of large surfaces with a powerful mobile
dust extractor.
The user is liable for improper or non-in­
tended use.
4

Technical data

Surface-restoration
grinders
2
Power
EU
2
CH
GB
AUS
Frequency
Power consumption
Speed (no-load)
Sanding disc diameter
CAUTION
RG 130 ECI
220–240 V~
230 V~
110 V~/230 V~
220–240 V~
50–60 Hz
1600 W
2200–6500 rpm
130 mm