Parts Of The Device; Commissioning; Switch On/Off - Festool RG 130 ECI Manual De Instrucciones

Surface-restoration
grinders
Dust extraction connec­
tion
Frequency
Equivalent Isotropically
Radiated Power (EIRP)
Weight as per EPTA
procedure 01:2014
5

Parts of the device

[1-1]
Handle
[1-2] Speed control
[1-3]
Bluetooth
[1-4]
LED indicator
[1-5] Handle screw
[1-6]
Auxiliary handle
[1-7] Spindle lock
[1-8]
Tilting brush segment
[1-9] Brush
[1-10] Extraction attachment
[1-11]
Locking button
[1-12] On/off switch
[1-13]
Dust screen
The specified illustrations appear at the begin­
ning of the Operating Instructions.
6

Commissioning

WARNING
Risk of injury, electric shock
► Always disconnect the mains plug from the
socket before performing any work on the
machine.
WARNING
Unauthorised voltage or frequency.
Risk of accidents
► The mains voltage and the frequency of the
power source must correspond to the
specifications on the name plate.
► In North America, only Festool machines
with the voltage specifications 120 V / 60 Hz
may be used.
RG 130 ECI
36 mm
2402 MHz-2480 MHz
< 10 dBm
3.9 kg
® button
CAUTION
Breaking and flying insertion tools
Risk of injury
► Do not use any damaged insertion tools.
After switching on the power tool and be­
fore each use, check the insertion tools for
vibration.
CAUTION
Materials which produce a lot of dust
Damage to the power tool due to the ingress
of dust, risk of injury
► Do not work overhead.
► Always work with a dust screen.
6.1

Switch on/off

The switch [1-12] is an on/off switch (press =
ON, release = OFF).
The on/off switch [1-12] with the locking but­
ton [1-11] can be engaged to operate in contin­
uous mode. Press the on/off switch [1-12]
again to release the lock.
6.2 Electronics
Smooth start-up
The electronically controlled smooth start-up
function ensures that the power tool starts up
smoothly. The limited starting current ensures
that even standard household fuses are not
triggered.
Speed control
You can use the speed control [1-2] to continu­
ously adjust the speed within the speed range
(see section 4).
The required speed depends on the sanding
disc and the material.
Overload safety device
The power supply is restricted if the power tool
is overloaded to extremes. The power supply is
disconnected completely if the motor jams for
some time. You will need to remove the load
and/or switch off the power tool before you can
use it again.
Restart protection
The built-in restart protection prevents the
power tool from starting up again automatically
if the power is disconnected during continuous
use. To put the power tool back into operation,
it must first be switched off and then on again.
English
21