American Standard Ovation Curve AM00847400 Manual Del Propietário página 10

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

3
INSTALLING DOOR PANEL AND HINGES
• In this step, you'll need following parts:[4] x1, [6] x1, [9] x1, [13] x2, [19] x2
[10]
3c
3b
3a
3a
3e
[10]
[9]
Correct Alignment
3a. Slide notch of Fixing L [19] into bottom of Fixed Panel A [10]. Attach Bottom Threshold [4] into opposite
side of Fixing L [19] as illustrated. Attach Fixing R [20] onto Fixed Panel B [11] and Bottom Threshold [4]
in the same way on the opposite side.
3b. Press Side Gasket [6] fully onto edge of Fixed Panel A [10].
3c. On one side of Hinge [13] remove the two screws and plastic washers as illustrated. Repeat for second
Hinge [13]. Attach one of the Hinges [13] at the holes of Fixed Panel A [10], then place the plastic washer
and screw into the hole. Ensure the plastic washer stays within the hole of the Fixed Panel A [10] and
lightly tighten the two screws. Repeat installation for the second Hinge [13] onto Fixed Panel A [10].
3d. Remove the single screw and washer from both Hinges [13]. Carefully position and install Door Panel [9]
over each of the Hinges [13] and insert the washer and screw into each hole of Door Panel [9] keeping the
washer within the hole of the door panel. Lightly tighten both screws.
3e. Observe that both Hinges [13] are straight and even (ref. illustration 3e). Once both hinges are straight,
securely tighten all screws on both hinges using supplied 4mm Allen Key [25].
3f. Snap cover caps over each screw of both Hinges [13] to cover screws.
[11]
[9]
View from
Outside
[10]
[9]
Incorrect Alignment
3a
[19]
[10]
[4]
3c
[13]
[10]
3d
[13]
[10]
[9]
3b
[10]
[6]
3e
[9]
[10]
[13]
[25]
View from
Inside
3f
[10]
[13]
[9]
View from
Inside

Publicidad

Tabla de contenido
loading

Tabla de contenido