Screws St4X25 - American Standard Ovation Curve AM00847400 Manual Del Propietário

7
INSTALLATION OF SUPPORT BAR
• In this step, you'll need following parts: [3], [16], [17], [18]
• In this step, you'll need the following tool: G
7a. Remove Bracket Mount from the Wall Bracket [17] (illustrated) and install into previous drilled hole from
steps 1d to 1g on the shower wall using one ST4x35 Screw [16]. Repeat installation on the opposite side.
7b. Slide Wall Bracket [17] over piece screwed into shower wall, then place Support Bar [3] into Wall
Bracket [17] on opposite end. Align Support Bars [3] 4 clips over the top edges of Fixed Panels A & B.
Repeat installation of Wall Bracket [17] on opposite side.
7c. Align Support Bar [3] clips over top edges of Fixed Panels A&B and turn set screws of the Support Bar
clips clockwise using supplied 4mm Allen Key [25] to secure Support bar to the Fixed Panels A&B.
7d. Tighten all set screws of both Wall Brackets [17] using supplied 2.5mm Allen Key [24].
7e. Once Support Bar [3] is completely installed, observe if there are any gaps between Side Gasket [6] and
Door Panel [9].
7f. If any gaps exist along the length of Side Gasket [6] and Door Panel [9], the Side Gasket [6] can be moved
in or out to provide a proper water tight seal (ref. illustration for Correct Fit).
7a
G
Bracket
Mount
[16]
Bracket
Screw
Mount
ST4x35
[3]
7c
[25]
[18]
View from Inside
[9]
7e
[6]
[10]
Incorrect Fit
[10]
7b
[17]
[3]
[24]
7d
[17]
[3]
7f
[6]
[10]
[9]
[6] [9]
Correct Fit