Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Unpacking
• If the appliance has been damaged during
transportation, you should immediately notify the
company responsible for delivering it.
• Carefully lift out the water purifier by taking hold of
the rear handle and the front edge. The water
purifier can be damaged if it is lifted in any other
way.
• Check the purifier for any signs of damage and
check that no accessories are missing. Any
damage, faults or missing parts should be notified
to the supplier immediately.
• Do not leave packaging material lying around so
that children can play with it.
Positioning the water purifier
Remember the following when installing the water
purifier:
• The purifier is installed upright, without support, on
a horizontal surface that can take the load.
• The installation space should be close to cold
water supply, drainage and an earthed electrical
supply.
• It should be easy to inspect the control panel.
• It should be possible to open the front cover so
that the filter containers can be accessed.
• The water purifier should be installed with a 2 cm
gap to any adjacent fittings or walls to ensure good
ventilation around the appliance.
• Connections can be routed in any direction from the
connection point. Make sure no connections are
crushed or damaged. Hoses and cables must not be
tensioned. The dimensions of the area required for
the water purifier are specified in fig. A.
Affixing the information decal
The accessory box contains an adhesive sheet
with information decals in various languages.
Select the required language and affix the decal at
the indicated place, see fig. B.
Water connection
Feed connection: The water purifier is connected to
cold water (2 - 40 °C) via the feed water hose, see fig.
C(3). The connection should be supplied with an easily
accessible shut-off valve, see fig. D. If the connection
is with new pipes or pipes that have not been in use for
an extended period, the water should be allowed to run
for a while before the hose is connected. Any sand and
rust are then flushed out.
1. Check that the black seals are in place in the
feed water hose's two connections.
2. Screw the feed water hose's straight end
onto the shut-off valve as shown in fig. D. If
the 3/4" hose connection does not fit, it can
be changed to a 1/2" connection using the
adapter supplied. Put the black washer in the
adapter and screw the adapter onto the shut-
off valve for feed water. Screw the feed water
hose onto the adapter.
INSTALLATION
A
B
C
1
D
17
2
3
Publicidad
Tabla de contenido
