Using The Water Purifier; Production Of Purified Water; Automatic Flushing; Regular Care Of The Water Purifier - Confidence RO 400C Manual De Instrucciones

USING THE WATER PURIFIER

When the water purifier has been installed, flushed and calibrated according to the instructions, it is ready to
be used. The water purifier has an electronic control system that makes it easy to use. Remember the
following:
• Change the filter when filter replacement is indicated on the control panel (2–3 times/year).
• Clean the water purifier when the flow is reduced and/or at least every 6 months.

Production of purified water

The water purifier starts production of purified
water when a tap, valve or pressure tank releases
the pressure in the purified water hose (i.e. when
the tap or valve is opened or when the pressure in
the tank falls) that is connected to the water
purifier.
Only use the water from the water
purifier when purification level II or III is
indicated.
If the water purifier has not been used for a
while, it can take up to 60 seconds before
good water quality is achieved.

REGULAR CARE OF THE WATER PURIFIER

Listed below are things you need to remember in the regular care of your water purifier. The points are listed
according how often they need to be performed:
• Every day, check that the indicator lights are
not indicating that something is calling for
remedial action.
• Keep the water purifier clean. Externally, the
appliance may only be cleaned with a damp
cloth. Do not use a wet cloth and do not pour
water over the appliance. Do not use
detergents.
• Once a month, check that all the connections
are in place and are watertight. Wipe off any
condensation that has collected on the base
plate.
• Make sure that you always replace filters in
time. The lifetime of the pre-filters depends on
your feed water.
After replacing a filter, stand the filter so that
most of the water runs out over a few minutes.
The filters can be discarded with normal

Automatic flushing

• Every time after drawing water, or every
15 minutes in each operating cycle, automatic
flushing takes place. The length of the flushing
process varies between 5-90 seconds,
depending on how long the previous drawing
of water lasted.
• When the water purifier is connected to water
and electricity, flushing is automatically
performed every 12 hours. Flushing takes
place regardless of when purified water was
last produced.
household rubbish, as they do not contain any
environmentally hazardous substances.
• Depending primarily on the hardness of the
feed water and its content of microorganisms,
the water purifier should be cleaned when the
flow is reduced or at least every 6 months and
disinfected if the water smells or tastes bad.
• When the capacity of the purifier is reduced
even after filter replacement and cleaning,
contact your dealer for membrane replacement.
• If the feed water has been classed as unfit, the
water from the water purifier should be tested
once a year by an approved laboratory.
• If the water purifier will not be used for a period
of more than four months, or if it is to be
disconnected from the water and electricity for
an extended period (several days), it should be
put into storage.
8