Flushing - Confidence RO 400C Manual De Instrucciones

Electrical connection
1. Connect the plug to the wall socket, see
fig. G.
2. The water purifier starts and flushes.
The water purifier conducts this flushing
operation every time the plug is
connected.
The water may not be used until the
flushing procedure as described in
the section "Flushing" has been
completed.
3. Start purified water production and
check that the connections are
watertight following installation. If any of
the connections leak, pull out the plug
and further tighten the hose clip or nut.
Connect the plug.
4. Post-tighten the reject water and feed
water hoses after one week's use.
A few drops of leakage at either end
of the purified water hose is sufficient
for the water purifier to start
(involuntarily). Leakage outside the
water purifier cannot be discovered
by its safety system. Unless
otherwise indicated, the shut-off
valve must always be open for the
water purifier's safety system to
work.
G

Flushing

Flushing is performed when the water purifier:
•
Is new and has never been used before.
•
Is reinstalled after having been in storage.
•
Has been cleaned, in order to rinse out
the detergent.
•
Has been supplied with a new membrane.
Purified water may not be drunk/used
before or while flushing is in progress.
First check that:
•
Purified water production has stopped.
•
The purified water hose is disconnected
from any peripheral equipment and routed
to the reject water outlet.
•
The shut-off valve on the feed water pipe
is open.
•
There are no leaks at the feed water
connection.
•
The reject water and purified water
connections are watertight.
•
The pre-filters are properly tightened.
1. Pull the plug out of the wall socket.
2. Connect the plug to the wall socket again.
The water purifier flushes automatically.
3. Restart the water purifier so that it flushes
automatically by pulling out and
reconnecting the plug again.
4. Restart the water purifier one more time.
5. New installation or membrane
replacement
Perform calibration according to the
section "Calibration".
5. Just flushing
Allow the water purifier to flush purified
water to the reject water outlet via the
purified water hose. If no tap is installed,
this takes place automatically. Pull out the
plug after 10 minutes and connect the
purified water hose to any peripheral
equipment. If the tap is installed, open the
tap and allow the water purifier to produce
purified water for 10 minutes. Close the
tap.
The water purifier is now ready to produce
purified water.
19
INSTALLATION