Moving The Display; Preventing The Display From Falling Over; Basic Connections - Pioneer KRP-500A Manual De Instrucciones

05 Preparation

Moving the display

When installing on a rack, etc., hold the display as shown below.
Because the display is heavy, be sure to have someone help you
when moving it.
Note
• Do not use the speaker to support the weight of the display.
• Do not hold the display by the speaker mounting fittings.

Preventing the display from falling over

After installing the stand, be sure to take special care to ensure
that the display will not fall over and is stabilized to both the wall
and rack.
Stabilizing on a table or rack
Stabilize the display as shown in the diagram using the falling
prevention metal fittings and screws supplied with the optional
stand.
Note
• Before stabilizing the display on a stand or rack, make sure that
the falling prevention metal fittings are attached to the stand.
• To stabilize the display on a table or rack, also use
commercially available wood screws that have a nominal
diameter of 4 mm and that are at least 20 mm long.
20 mm min.
Wood screw
(commercially available,
4 mm x 20 mm min.)
Drill a hole in the middle at the rear of the tabletop panel before
using a wood screw. Perform this work the same way on the left
and right sides.
16
En
All manuals and user guides at all-guides.com
Falling prevention
metal fitting
Using a wall for stabilization
1 Attach falling prevention bolts (hooks) to the display.
2 Use strong cords to stabilize it appropriately and firmly to
a wall, pillar, or other sturdy element.
Perform this work in the same way on the left and right sides.
Use hooks, cords and fittings that are available on the market.
Recommended hook: Nominal diameter 8 mm, length 12 mm to
18 mm
1. Hook
2. Cord
Fitting
Caution
• A table or rack with adequate strength should always be used
to support the display. Failure to do so could result in personal
injury and physical damage.
• When installing the display, please take the necessary safety
measures to prevent it from falling or overturning in case of
emergencies, such as earthquakes, or of accidents.
• If you do not take these precautions, the display could fall down
and cause injury.
• The screws, hooks, cords and other fittings that you use to
secure the display to prevent it from overturning will vary
according to the composition and thickness of the surface to
which it will be attached.
• Select the appropriate screws, hooks, cords, and other fittings
after first inspecting the surface carefully to determine its
thickness and composition and after consulting a professional
installer if necessary.
• Do not use bare wires for the cord. If any part of the wire is
introduced into the ventilation port on the back of the display
panel, fire or electrical shock could result.

Basic connections

Connecting the antenna
To enjoy a clearer picture, use an outdoor antenna. The following is
a brief explanation of the types of connections that are used for a
coaxial cable.
12 mm to 18 mm