Installing Fluorescence Filter (B-510Fl) - Optika B-510 Serie Manual De Instrucciones

8. Using the multipower cable, plug the fluorescence power
supply in the connector ① on the back side of the fluores-
cence illuminator. (Fig. 34)
9. Insert the power supply jack in the connector ② placed at the
rear side of the microscope. (Fig. 35)
8.8

Installing fluorescence filter (B-510FL)

1. Remove the illuminator from the stand and place it on the
desk.
2. Loosen the locking screw ① of the filter slider with an Allen
wrench provided. (Fig. 36)
3. Remove the filter slider from the illuminator.
4. Use a Phillips screwdriver to unscrew the four screws ② to
open the filter slider. (Fig. 37-38)
①
①
②
Page 32
②
②
②
F F ig. 34 ig. 34
F ig. 35 F ig. 35
F ig. 36 F ig. 36
②
F ig. 37 F ig. 37