Baby auto GIROTO 0123 Manual De Uso página 30

4. INSTALLING THE CHILD SEAT REARWARD FACING
GROUP 0+
NOTICE
1. Before installing the child seat, the position of the seat must be
adjust to rearward facing. To do it, pull and keep up the lock system
of the seat base
2. Place the child safety seat in the back seat of the vehicle facing in
the opposite direction of travel ensuring it is resting firmly against
the backrest.
3. Unlock the harness to help seat installation.
4. Take out the reducer cushion
5. Pass the abdominal strap of the seat belt through the lower seat
guides (J)
click (fig.4.2).
6. Pass the diagonal section of the seat belt through the
corresponding upper guide (L).
7. Take the remaining slack of the diagonal section of the 3-point
seat belt. And make sure it is as tight fitting as possible.
8. Ensure the straps are not twisted or knotted at any point.
9. Place back the reductor cushion
CAUTION! Remove the reducing pad
5. INSTALLING THE CHILD SEAT FORWARD FACING
GROUP 1
NOTICE
WARNING! once the car seat is installed, if another recline position
is selected, you should check the tension of the Top Tether system.
1. Before installing the child seat, select 1, 2, 3 or 4 recline positions
(fig. 5.1). Pull the lever
without releasing the lever until the seat is in the desired position.
30
(3 POINTS BELT ONLY)
GROUP 0+ only. From birth to 12 months
approx. (0-13 kg)
(S)
(fig.3.1). Rotate the seat to rearward facing (fig.3.2).
(fig. 4.1) and buckle the vehicle seat belt until you hear a
(ISOFIX+TOP TETHER)
GROUP 1 only. From 9 months to 4 years
approx. (9-18 kg)
(I) forward and adjust the angle of recline
(K)
from the seat.
(K) on the seat.
(K)
from 8 kg and above.