Metabo HPT DS 18DC Instrucciones De Seguridad Y Manual De Instrucciones página 18

English
Work
Wood screw
(DS18DC / DV18DC)
Screw
tightening
(DV36DC)
Wood
(DS18DC / DV18DC)
Drilling
(DV36DC)
13. Remaining battery indicator
You can check the battery's remaining capacity by
pressing the remaining battery indicator switch to light
the indicator lamp. (Fig. 19, Table 8)
The indicator will shut off approximately 3 seconds
after the remaining battery indicator switch is pressed.
It is best to use the remaining battery indicator as
a guide since there are slight diff erences such as
ambient temperature and the condition of the battery.
Also, the remaining battery indicator may vary from
those equipped to a tool or charger.
State of lamp
Lights ;
The battery remaining power is
over 75%.
Lights ;
The battery remaining power is
50%–75%.
Lights ;
The battery remaining power is
25%–50%.
Lights ;
The battery remaining power is
less than 25%.
Blinks ;
The battery remaining power
is nearly empty. Recharge the
battery soonest possible
Blinks ;
Output suspended due to high
temperature. Remove the
battery from the tool and allow it
to fully cool down.
18
Cap
Position
1 –
Table 8
Battery Remaining Power
Table 7
Rotating speed selection (Position of the shift knob)
1 (Low speed)
For 7/16 in. (12 mm) or smaller
diameter screws.
For 5/8 in. (16 mm) or smaller
nominal diameter screws.
For 4 in. (102 mm) or smaller
diameters.
For 4-5/8 in. (118 mm) or
smaller diameters.
As the remaining battery indicator shows somewhat
diff erently depending on ambient temperature and
battery characteristics, read it as a reference.
Remaining battery
indicator lamp
NOTE
Do not give a strong shock to the display panel or
break it. It may lead to a trouble.
14. How to use the LED light
While the switch is pulled, the LED light will
automatically light up the tip portion of the tool.
(Fig. 20)
The LED light will automatically turn off 10 seconds
after the switch is released.
The LED light also functions as a warning signal that
lights up during use.
For details, see "17. LED light warning signals".
2 (High speed)
For 1/4 in. (6 mm) or smaller
diameter screws.
For 5/16 in. (8 mm) or smaller
nominal diameter screws.
For 1-1/2 in. (38 mm) or smaller
diameters.
For 2-1/8 in. (54 mm) or smaller
diameters.
Blinks ;
Output suspended due to failure
or malfunction. The problem
may be the battery so please
contact your dealer.
Remaining battery
indicator switch
Display panel
Fig. 19