Specific Safety Rules And Symbols - Metabo HPT DS 18DC Instrucciones De Seguridad Y Manual De Instrucciones

English
d) Under abusive conditions, liquid may be
ejected from the battery; avoid contact. If
contact accidentally occurs, fl ush with water.
If liquid contacts eyes, additionally seek
medical help.
Liquid ejected from the battery may cause irritation
or burns.
e) Do not use a battery pack or tool that is
damaged or modifi ed.
Damaged or modifi ed batteries may exhibit
unpredictable behaviour resulting in fi re, explosion
or risk of injury.
f) Do not expose a battery pack or tool to fi re or
excessive temperature.
Exposure to fi re or temperature above 265 °F may
cause explosion.
g) Follow all charging instructions and do
not charge the battery pack or tool outside
the temperature range specifi ed in the
instructions.
Charging improperly or at temperatures outside
the specifi ed range may damage the battery and
increase the risk of fi re.
6) Service
a) Have your power tool serviced by a
qualifi ed repair person using only identical
replacement parts.
This will ensure that the safety of the power tool is
maintained.
b) Never service damaged battery packs.
Service of battery packs should only be performed
by the manufacturer or authorized service
providers.
– WARNING –
To reduce the risk of injury, user must read
instruction manual.

SPECIFIC SAFETY RULES AND SYMBOLS

1. Wear ear protectors with impact drilling.
Exposure to noise can cause hearing
loss.
2. Use auxiliary handle(s).
Loss of control can cause personal injury.
3. Brace the tool properly before use.
This tool produces a high output torque and without
properly bracing the tool during operation, loss of
control may occur resulting in personal injury.
4. Hold the power tool by insulated gripping
surfaces, when performing an operation where
the cutting accessory or fasteners may contact
hidden wiring.
4
Cutting accessory or fasteners contacting a "live" wire
may make exposed metal parts of the power tool "live"
and could give the operator an electric shock.
Safety instructions when using long drill bits
5. Never operate at higher speed than the maximum
speed rating of the drill bit.
At higher speeds, the bit is likely to bend if allowed
to rotate freely without contacting the workpiece,
resulting in personal injury.
6. Always start drilling at low speed and with the bit
tip in contact with the workpiece.
At higher speeds, the bit is likely to bend if allowed
to rotate freely without contacting the workpiece,
resulting in personal injury.
7. Apply pressure only in direct line with the bit and
do not apply excessive pressure.
Bits can bend causing breakage or loss of control,
resulting in personal injury.
8. Make sure to securely hold the tool during
operation.
Failure to do so can result in accidents or injuries.
(Fig. 1)
9. Never place hands or other body parts near the drill
bit or chuck during operation. Hold the drill by its
handle only.
10. Because the cordless tool operates by battery power,
be aware of the fact that it can begin to operate at any
time.
11. When working at elevated locations, clear the area
of all other people and be aware of conditions below
you.
12. Never touch moving parts.
Never place your hands, fi ngers or other body parts
near the tool's moving parts.
13. Never operate without all guards in place.
Never operate this tool without all guards or safety
features in place and in proper working order. If
maintenance or servicing requires the removal of a
guard or safety feature, be sure to replace the guard
or safety feature before resuming operation of the
tool.
Fig. 1