Metabo HPT DS 18DC Instrucciones De Seguridad Y Manual De Instrucciones página 19

CAUTION
● Do not expose directly your eye to the light by
looking into the light.
If your eye is continuously exposed to the light,
your eye will be hurt.
● Wipe off any dirt or grime attached to the lens of
the LED light with a soft cloth, being careful not
to scratch the lens.
Scratches on the lens of the LED light can result
in decreased brightness.
15. Using the hook
The hook is used to hang up the power tool to your
waist belt while working.
CAUTION
● When using the hook, hang up the power tool
fi rmly not to drop accidentally.
If the power tool is dropped, it may lead to an
accident.
● When electing to carry the tool hooked to your
hip belt, make sure to detach the tool bit and side
handle.
Failure to do so may result in unexpected injury.
● Install securely the hook. Unless the hook is
securely installed, it may cause an injury while
using.
(1) Mounting the hook
Install securely the hook in the groove of power tool
and tighten the screw to fi x the hook fi rmly. (Fig. 21)
Hook
Trigger switch
Fig. 20
Groove
Screw
Fig. 21
(2) Removing the hook
Loosen the screw fi xing the hook with Philips screw
driver. (Fig. 22)
Hook
16. RFC (Reactive force control)
This product features RFC.
This stops the motor automatically if the tool is jerking
excessively.
The LED light fl ashes to indicate that RFC has been
activated.
If this occurs, release your fi nger from the switch
before restarting. (Fig. 23)
NOTE
● RFC may not always activate under certain working
conditions or situations.
● Take care to hold the tool fi rmly to prevent any jerking
motion.
● RFC may also activate if you change position
suddenly while holding the tool.
English
Groove
Screw
Fig. 22
Fig. 23
19