Kichler cULus 300285/85-GENT Serie Manual De Instrucciones página 10

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

HANGING THE FAN (continued)
Step 8. Slip the coupling cover, canopy cover and canopy onto the
downrod. (Fig. 10)
Thread the hanger ball onto the downrod, insert the cross pin
through the downrod and tighten. Tighten the set screw.
Step 9. Lift the motor assembly into position and place the
hanger ball into the ceiling mounting bracket.
Rotate the entire assembly until the "Check Tab" has dropped into
the "Registration Slot" and seats firmly. (Fig. 11)
The entire motor assembly should not rotate (left or right) when
seated properly.
WARNING: Failure to reattach the cross pin and seat the
"Check Tab" can cause the fan to fall from the ceiling during
operation. Take special care to make sure this pin is reattached.
10
| KICHLER.COM
Downrod
Coupling cover
Coupling
Hitch pin
Registration
slot
Canopy
Canopy cover
Set screws
Retaining clip
Fig. 10
Check
tab
Fig. 11

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido