Kichler cULus 300285/85-GENT Serie Manual De Instrucciones página 9

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

HANGING THE FAN (continued)
Cross pin
Step 5. Remove the hanger ball from the downrod assembly by
loosening the set screw, unscrewing and removing the cross pin and
Hanger ball
unscrewing the ball off the rod. (Fig. 8)
Set screw
Step 6. Loosen the two set screws and remove the hitch pin and
Downrod
retaining clip from the coupling on top of the motor assembly. (Fig. 9)
Fig. 8
Step 7. Carefully feed the electrical lead wires from the fan up
through the downrod. Thread the downrod into the coupling until the
hitch pin holes align.
Next, replace the hitch pin and retaining clip. Tighten both set screws.
Supply wires
(Fig. 9)
Downrod
Coupling
Set screws
Retaining clip
Set screws
Hitch pin
Fig. 9
9
60"/65"/85" GENTRY

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido