Installing The Led Light Kit; Installing Glass Shade - Kichler cULus 300285/85-GENT Serie Manual De Instrucciones

INSTALLING THE LED LIGHT KIT

CAUTION: "To reduce the risk of electric shock, disconnect the
electrical supply circuit to the fan before installing light kit."
Step 1. Loosen the three mounting screws on the inside of the LED
light kit. (Fig. 17)
Step 2. While holding the LED light kit under the fan motor, make the
wire connections: (Fig. 17)
- White to white
- Black to black
Step 3. Tuck the connections neatly into the light plate. Place the
key holes on the LED light kit over the 2 screws previously loosened
from the light plate, turn the LED light kit until it locks in place at
the narrow section of the key holes. Secure by tightening all three
screws. (Fig. 17)
INSTALLING THE GLASS SHADE
Raise the glass shade against the light plate and secure by tightening
all three screws (Fig. 18)
16
| KICHLER.COM
Wire connectors
LED light kit
Glass shade
Light plate
Screws
Fig. 17
Screws
Fig. 18