To Stop The Engine - Maruyama P23-10 Manual Del Operador

and move the stop switch to the "ON" position.
2. Move the choke lever to the closed (
and move the stop switch to the "ON" position.
3. Lock the throttle trigger in the fast-idle start
position, then pull the starter grip.
Fast-idle start lock
STOP(OFF)
Stop switch
• Do not pull the Starter rope all the wayout.
WARNING
• Do not disassemble the Starter. Please ask for
an authorized MARYAMA service dealer.
4. After the engine starts, squeeze and release the
throttle trigger to return it to the idle position, then
move the choke lever to the open (
If the engine stops running before you move the
choke lever to the open (
A. Go ahead and open the choke.
B. Make sure the throttle trigger is set to the idle
position.
C. Pull the starter grip until the engine starts.
Hot Restart
To start an engine that is already warmed up (hot
restart), or if the ambient temperature exceeds 68°F
(20°C):
1. Pump the primer bulb at the bottom of the car-
buretor until fuel can be seen flowing through the
fuel return line to the fuel tank.
) position
START(ON)
Fast-idle start
position
Idle position
CAUTION
) position.
) position:
To start an engine that is already warmed up (hot
Hot Restart
restart), or if the ambient temperature exceeds 68°F
To start an engine that is already warmed up (hot
(20°C):
restart), or if the ambient temperature exceeds 68°F
(20°C):
1. Pump the primer bulb at the bottom of the car-
buretor until fuel can be seen flowing through the
1. Pump the primer bulb at the bottom of the car-
fuel return line to the fuel tank.
buretor until fuel can be seen flowing through the
fuel return line to the fuel tank.
2. Move the choke lever to the open (
and move the stop switch to the "ON" position.
2. Move the choke lever to the open (
and move the stop switch to the "ON" position.
3. Leave the throttle trigger in the idle position and
pull the starter grip.
3. Leave the throttle trigger in the idle position and
pull the starter grip.
4. If the engine fails to start after three to four pulls,
follow the instruction in the Cold Starting Procedure
section (page US-17).
If the engine fails to start after you follow the
above procedures, contact an authorized
Maruyama dealer.

To Stop The Engine

1. Release the throttle trigger.
2. Slide the stop switch to the "STOP" position.
Fast-idle start lock
STOP(OFF)
Stop switch
− US-18 −
) position
) position
START(ON)
Fast-idle start
position
Idle position