Sharpening Saw Chain; Adjusting Depth Gauge - Maruyama P23-10 Manual Del Operador

5. Reinstall the spark arrester and tail onto muffler,
then reinstall and tighten the two socket head
screws.
6. Reinstall the cylinder cover and the air filter cover.

Sharpening saw chain

Whenever wood chips become small and fine or the
wood cannot be cut without pressing the pruner hard
against it, then it may be necessary to sharpen the saw
chain.
1. Tighten the saw chain slightly firmer than usual then
secure the pruner's main unit.
2. Place a file with a 4.0 mm (5/32 inch) diameter
against the cutter and extend 1/5 of it beyond the
cutter.
3. Press the file against the cutter at its base in a
30-degree angle from the vertical line and move the
file straight ahead from the inner side to the outer
side of the cutter.
4. Shift the file so that it remains in a 90-degree angle
against the guide bar.
5. Once one side of the cutter is sharpened, sharpen the
other side of the cutter. Be sure to keep the length
and angle uniform throughout.
IMPORTANT
• The efficiency of this work greatly impacts
t h e s h a r p n e s s o f t h e c u t t e r . I t i s
r e c o m m e n d e d t h a t s h a r p e n i n g b e
performed often.
• Be sure to use an appropriate file for
sharpening the saw chain cutters.

Adjusting depth gauge

The depth gauge determines how deep the cutter cuts
into the wood.
1. When the cutter lengths become shorter due to
sharpening, the depth gauge must also be cut back.
30°
Maintain uniform lengths of cutters
Depth gauge setting
Side plate filing angle
Cutter Maintenance Specifications
− US-24 −
90°
File
Guide bar
Sharpen shaded area
0.64mm
Top plate
Depth gauge
cutting angle
80°
30°
Top plate filing angle
30°
55°