Snooze Function; Care And Maintenance - Emos E3003 Manual De Instrucciones

Snooze Function

The alarm ringing can be delayed by 5 minutes using the SNOOZE button – slightly pressing the top
of the station downwards.
Press the button when the alarm starts ringing. The zZ icon will flash.
To cancel the SNOOZE function, press any button on the back of the station – the zZ will disappear.
The alarm will be re-activated the next day.
The alarm ringing will be active for 2 minutes if no button is pressed.
MAX – MIN Temperature
Repeatedly pressing the UP button will show information about the maximum/minimum temperature
measured.
When in the max/min display mode, you can erase the memory by long pressing the UP button.
Temperature Alert
You can set a temperature alert for a maximum of 3 connected sensors.
A different temperature alert value can be set for each sensor.
Select sensor 1/2/3 by repeatedly pressing the CHANNEL button on the weather station.
Long press the DOWN button on the weather station and then activate (ON) or deactivate (OFF) the
temperature alert function by repeatedly pressing the button.
Press the MODE button to confirm your choice and set the highest temperature value using the UP/
DOWN buttons ( icon will be displayed), then press the MODE button and set the lowest temperature
value ( icon will be displayed).
The temperature limit can be set between -50 °C and +70 °C, in 1 °C increments.
If the sensor measures the set value, the weather station will start beeping, and a
temperature will be displayed.
The audio signal can be temporarily muted by pressing on the top of the weather station downwards.
The temperature alert will deactivate if the temperature drops below the set value or if you deac-
tivate it manually.

Care and Maintenance

The product is designed to provide trouble-free service for many years if used appropriately. Here is
some advice for proper operation:
• Read the manual carefully before using this product.
• Do not expose the product to direct sunlight, extreme cold and moisture, and sudden changes in
temperature. This would reduce accuracy of detection.
• Do not place the product in locations prone to vibration and shocks – these may cause damage.
• Do not expose the product to excessive force, impacts, dust, high temperatures or humidity – these
may cause malfunction, shorter battery life, damage to batteries and deformation of plastic parts.
• Do not expose the product to rain or moisture, if it is not designed for outdoor use.
• Do not place any open flame sources on the product, e.g. a lit candle, etc.
• Do not place the product in places with inadequate air flow.
• Do not insert any objects in the product's vents.
• Do not tamper with the internal electric circuits of the product – doing so may damage the
product and will automatically void the warranty. The product should only be repaired by a
qualified professional.
• To clean the product, use a slightly moistened soft cloth. Do not use solvents or cleaning agents
– they could scratch the plastic parts and cause corrosion of the electric circuits.
• Do not immerse the product in water or other liquids.
• The product must not be exposed to dripping or splashing water.
• In the event of damage or defect on the product, do not perform any repairs by yourself. Have it
repaired in the shop where you bought it.
• This device is not intended for use by persons (including children) whose physical, sensory or
mental disability or lack of experience and expertise prevents safe use, unless they are supervised
or instructed in the use of the appliance by a person responsible for their safety. Children must
always be supervised and must never play with the device.
6
/ icon and