Setting An Alarm; Snooze Function - Emos E5080 Manual De Instrucciones

• Atmospheric disturbances, thunderstorms, electrical appliances with no interference elimination,
television sets and computers located near the DCF receiver.
If the weather station cannot detect the DCF signal, time and date must be set manually.
Note: If the weather station detects the DCF signal but the current time on the display is incorrect
(e.g. shifted ±1 hour), you must set the correct time zone for the country where you are using the
station, see Manual Setting of Time and Date. The current time will be shown with the appropriate
time zone difference.
Manual Setting of Time and Date
1. Press and hold the MODE button for 3 seconds.
2. Use + or – to set the following parameters: time zone – year – month – day – calendar language
(GER, FRE, SPA, ITA, DAN, DUT, ENG) – date display format – hours – minutes.
12/24 Hour Time Format
Set the time format to 12 or 24 h by repeatedly pressing the AM/PM button.

Setting an Alarm

The weather station allows you to set 2 separate alarm times.
Press the ALARM button repeatedly to view the alarm time for alarm no. 1 (A1) or 2 (A2).
Then long-press the ALARM button; the time value will start flashing.
Set the time by repeatedly pressing the + or – button; to navigate in the menu, press the ALARM
button again.
You can set the time for both alarms this way.
To activate alarm no. 1 move the AL 1 button to the ON position.
The icon will be displayed.
To activate alarm no. 2 move the AL 2 button to the ON position.
The icon will be displayed.
The alarm will then trigger at the set time.
To deactivate the alarm, move the AL 1/AL 2 button to the OFF position.

Snooze Function

Alarm ringing can be postponed by 5 minutes using the SNOOZE/LIGHT button located on the top of
the weather station.
Press the button when the alarm starts ringing. The alarm icon and Zz icon will be flashing.
To cancel SNOOZE mode, press any other button except SNOOZE/LIGHT – the icon will stop flashing
and will remain on the screen.
The alarm will be re-activated the next day.
If you do not press any button while the alarm is ringing, the ringing will stop automatically after
2 minutes.
The alarm will trigger again the next day.
Screen Illumination
Press the SNOOZE/LIGHT button to activate screen illumination for 10 seconds.
Setting °C/°F Temperature Unit
Repeatedly press the MODE button to set the temperature unit (°C/°F).
Displaying Maximum and Minimum Temperature and Humidity Readings
Repeatedly pressing the + button will gradually display the maximum (MAX icon) and minimum (MIN
icon) temperature and humidity readings.
To manually erase the memory of measured values, long press the + button.
The memory of measured values is automatically erased every day at 00:00.
Atmospheric Pressure/History
The station displays atmospheric pressure in hPa/inHg in field no. 4 and also shows a pressure history
in the last 12 hours in field no. 5. When the station is moved to a new location, the measured values
will be affected. Measurement will stabilise within 12 hours of battery insertion or station relocation.
6