Forward-Facing Installation Harness Mode; Vehicle Lap-Shoulder Belt (Preferred Method) - Britax ONE4LIFE CLICKTIGHT Guia Del Usuario

9 Both red CLICKTIGHT release buttons are visible after installation.
9 All connections are secure and vehicle belt is not twisted.
9 Vehicle belt is locked as directed by your vehicle owner's manual.
9 Car seat base MUST be flat on vehicle seat and MUST be parallel to
vehicle seat.
9 Recline indicator is still within the correct section for rear-facing
after child is secured.
9 Child restraint cannot be moved front to back or side to side more
than 1 in. (2.5 cm) at the belt path.
9 Excess top tether webbing is contained within your vehicle and secured.
NOTE: If the child restraint does not meet the above criteria,
repeat the installation steps or use a different seating
location in your vehicle.

FORWARD-Facing Installation Harness Mode

Britax strongly recommends:
• children should ride REAR-facing until they exceed the
weight or height limits specified.
• the top tether be used at ALL times when installing the
child restraint FORWARD-facing. Using the top tether
will improve the stability of your child restraint and
reduce the risk of injury.
Use FORWARD-facing only:
• with harness straps in closest
position above the child's shoulder,
and
• with children weighing 22 - 65 lb
(10 - 29.5 kg), and
• who are 49 in (124.5 cm) or less in
height, and
• when the top of the ears are below
the top of headrest.
IMPORTANT:
forward-facing.
Installation with Vehicle Lap-Shoulder Belt (Preferred
Method)
1. Extend the top tether strap
by lifting on the top tether
adjuster.
24
Anti-rebound bar MUST be removed